
Mold Inspection
Where the water is getting in comes first, then how far the growth has spread behind the surface.
Mold InspectionColorado Springs Mold Experts connects homes in Briargate with independent providers. Newer north-side houses here are built tight and most have a finished basement. A tight house keeps heat in, and it keeps indoor moisture in too.

Where the water is getting in comes first, then how far the growth has spread behind the surface.
Mold Inspection
Contained work areas, filtered air and bagged debris, so the cleanup does not push spores through the house.
Mold Removal
Steam with nowhere to go settles on drywall and grout, and a weak fan is usually part of the story.
Bathroom and Kitchen MoldMost Briargate homes went up from the 1980s onward, with poured foundation walls, window wells and a sump. They are sealed far better than older housing, which is good for heating bills and hard on humidity: showers, cooking, laundry and a whole-house humidifier all put water into air that has nowhere to go in January.
The result shows up as water running down window glass, damp patches behind furniture on an outside wall and speckling in a basement corner. Below grade, a window well without a cover or a downspout discharging next to the wall is the other common source.
If the furnace has a humidifier, note what it is set to. Turning it down in the coldest weeks stops a lot of condensation problems by itself.
Say whether the lower level is finished and whether anything has ever come in through a window well, the sump or a floor drain.
Note whether the fans clear steam from the mirror in a few minutes. Weak or missing fans are behind much of the growth found in newer homes.
The fix in a tight house is usually about moving moisture out rather than adding equipment. Fans that run long enough, a humidifier dialed back and a window well that sheds water away from the house solve more than a dehumidifier hidden in a corner.
See bathroom and kitchen mold removal for the fan side, and our guide to preventing mold in a dry climate for winter settings. The removal versus remediation guide explains which scope a finding needs.
Colorado Springs Mold Experts also lists Monument to the north, and every community is listed on the service areas page.
Mostly it depends on how much finished material has to come out. A small patch of drywall is a short job; a basement wall behind built-in cabinets is not. Ask the independent provider to confirm the price after an inspection.
Colorado Springs Mold Experts connects callers in Briargate and the north-side neighborhoods with independent providers. Call and give your address; see the contact page for the number to call.
Scheduling depends on the provider and the property location, so ask the independent provider about timing when you call.
It is a warning. Water sitting on glass and sills every morning means the indoor air is carrying more moisture than the house can shed, and the same thing is happening inside cold wall cavities where you cannot see it.
Neither until it has been checked. Paint over a wet wall and the stain returns; tear out drywall that was only surface-stained and you paid for nothing. A meter reading decides it. See mold removal.
Newer homes are sealed tighter, so the moisture people make indoors stays indoors. Add a humidifier turned up and a finished basement against cold concrete and you get growth in a house with nothing wrong with it structurally. An independent provider should look at humidity and ventilation first in these homes.
Call and describe what you are seeing and where the water came from to reach an independent provider.